GATES OF WOOD AND WIRE.
wood and wire gateFig. 237.—A Neat Gate Of Scantling And Wire.
Fig. 237.—A Neat Gate Of Scantling And Wire.
Fig. 237.—A Neat Gate Of Scantling And Wire.
One of the cheapest and most popular styles of farm gate is made of plain or barbed wire, supported by wooden frames.Figure 237shows a very neat form of combination gate. To make it, obtain three uprights, three inches by one and a half inches, five and a half feet long, and four strips, three inches by one inch, eleven feet long. Cut shoulders in the ends of the strips, and saw out corresponding notches in the uprights;make these one and a half inch, or half the width of the strips. The bottom notch is two and a half inches from the end of the upright, and the upper one nine and a half inches from the top end. Fit the strips into the notches. There is then a space of one inch between the strips, into which put inch strips, so as to make all solid, and fasten together with carriage bolts. Braces three by one and a half inches are inserted, and held in place by bolts or wrought nails. Bore as many holes in the end-pieces for one-quarter inch eye-bolts, as it is desired to have wires. Twist the wire firmly into the bolts on one upright, and secure the other end to the corresponding bolts on the upright at the opposite end. In stretching the wires, pass them alternately on opposite sides of the center piece, and fasten in place by staples. This will, in a measure, prevent warping. By screwing down the bolts with a wrench, the wires may be drawn as tightly as desired. The hinges are to be put on with bolts, and any sort of fastening may be used that is most convenient. Barbed or smooth wire may be used.