The frame is composed of two sticks of silver spruce 38″ in length, ⁵⁄₁₆″ × ³⁄₁₆″, tapering to ¹⁄₄″ × ⁵⁄₃₂″, held apart by a streamline bamboo cross brace in the center. An additional brace of bamboo is securely fastened across the frame toward the front. The propeller brace consists of a streamline-cut piece of bamboo 12¹⁄₂″ in length by ³⁄₈″ in width at the center, tapering to ¹⁄₄″ toward the ends. The propeller brace is inserted in slots cut in the rear ends of the frame members, then bound and glued.
The propellers are bent from birch veneer, the bending being done over an alcohol flame as illustrated indiagram 15. But first of all the blades are cut to shape, sandpapered and finished before they are bent. As shown in the drawing a slot is filed in the hub of each blade to enable the propeller shaft to pass through when both have been glued together. The blades are then glued and bound together, first by placing a piece of wire in the slots to insure their being centered and also to prevent their being filled with glue. After this has been doneeach propeller is given three coats of the same dope as is used on the wings.
The propeller bearings are turned out of ¹⁄₃₂″ bronze tubing, the length of each bearing being ¹⁄₂″. Steel washers are slipped over the propeller shaft, between the bearing and propeller to insure smooth running. The propeller shafts are made from steel hatpins which are heated at both ends, one end of which is bent into a loop to receive the rubber strands, the other end being bent around the hub of the propeller to prevent the shaft from slipping during the unwinding of the rubbers. Two strips of brass, each ¹⁄₄″ × 2″, are bent around the one-half inch bearing and soldered. The brass strips are then glued and bound onto the ends of the propeller brace as shown indiagram 15.