Ofthe many different types of duration models that have made their appearance during the year of 1915 perhaps the model described herewith, constructed and flown by Mr. Rudolph Funk, of the Aëro Science Club, was one of the most successful. Unlike most models the propellers of this model are bent and not cut. This model made its appearance during the latter part of 1915, on several occasions having flown for over 100 seconds duration.Diagram 15.
While retaining the important characteristics of his standard model, slight changes have been made. Instead of the usual wire for the construction of the frame of the wings, bamboo is used in its place for lightness and strength. The wing frames are single surfaced, Chinasilk being used for covering. The “dope” which is used to render the silk airtight is made by dissolving celluloid in banana oil. This in turn is applied to the silk with a soft brush.
The camber of the main wing is ³⁄₄″ at the center, with a slight reduction towards the negative tips; it also has a dihedral angle of 2 degrees. The main beam, which is secured to the under side of the frame for rigidness, is of spruce 1″ by ⁵⁄₆₄″, tapering to ³⁄₄″ × ⁵⁄₆₄″. The ribs for the main wing and small wing or “elevator” are cut from solid pieces of bamboo ³⁄₁₆″ thick by ¹⁄₄″ wide. These pieces of bamboo are first bent to the proper camber and are then cut into strips each ¹⁄₁₆″ wide. The ribs are next tapered to a V at the bottom, toward the trailing edge, as shown indiagram 15, and also toward the entering edge. To accommodate the entering and trailing edges of the frame, each rib is slit slightly at both ends. Both edges of the frame are then inserted in the slots at the ends of the ribs and bound around with silk thread.