Indiagram 1the propellers are shown with the straight edge as the entering or cutting edge of the blade. Some of the model builders prefer the curved edge as the cutting edge (diagram 2). It is significant that Mr. Frank Schober, a well known model constructor, tested both designs on his compressed air driven model, and while both propellers were the same in weight, diameter and pitch, the one having the straight edge as the cutting edge was found one-third more efficient.
When the propellers have been given a light coat of shellac they should be laid aside until the assembling of the complete model.
By following the foregoing instructions a simple and effective set of propellers will be produced. But in order to vary the experimental practice of the constructor various other diagrams,Nos. 3and4, illustrating suitable designs, are provided and can be made by applying the above general theory and using the diagrams herewith.
Oneof the most important considerations in the construction of a model is the making of thewings. To obtain the greatest efficiency the wings must be carefully designed, with due attention to whether the model is being constructed for speed, duration or climbing ability. Attention should be given to streamline construction; that is, the parts of the wing should be so assembled that the completed wing would offer the least possible resistance to the air, if the best results are to be obtained.
For the main wing three strips of spruce, each 30″ in length, two of them being ³⁄₁₆″ × ¹⁄₄″ and the third ³⁄₁₆″ × ¹⁄₁₆″ are required. To make them thoroughly streamline all edges should be carefully rounded off and all surfaces should be smooth. A strip of bamboo at least 20″ long, ¹⁄₂″ wide, ¹⁄₈″ thick, should be cut into pieces, each piece to be 5 in. long. To secure the necessary curve, ¹⁄₂″ depth, the pieces of bamboo should be held in steam and slowly bent in a manner closely resembling the skids of an ordinary bobsled. When the curvature has been obtained, care should be exercised in cutting each piece into four longitudinal strips, from which twelve should be selected to be used as ribs, each to be ¹⁄₈″ wide. The bending of the bamboo preliminary to making the ribs is done in order to secure uniformity of curvature.