GATE HINGES OF WOOD.
using a branch as a hingeFig. 221.
Fig. 221.
Fig. 221.
board on post serving as hingeFig. 222.
Fig. 222.
Fig. 222.
It is often convenient and economical, especially in newly settled regions, where blacksmiths and hardware stores are not at hand, to supply hinges for gates, to make them of wood. The simplest and most primitive form is shown infigure 221. A post is selected having a large limb standing out nearly at right angles. A perpendicular hole in this secures the top of the rear gate standard. The foot rests in a stout short post, set against the main post. A small gimlet hole should extend outward and downward from the lowest side or point in the hole in the short post, to act as a drain, or the water collecting in it would be likely to soon rot both the standard and the short post itself. Another form is to hold the top by a strong wooden withe. A third form is illustrated infigure 222, in which the top of the standard passes through a short piece of sawed or split plank, spiked or pinned upon the top of the post.
wooden loop for a hingeFig. 223.—A Withe Hinge.
Fig. 223.—A Withe Hinge.
Fig. 223.—A Withe Hinge.
The form shown atfigure 223is made of a stout lithe sapling or limb of beech, hickory or other tough hard wood or, if it is attainable, a piece of iron rod.
gate using rounded stilesFig. 224.—Gate Without Hinges.
Fig. 224.—Gate Without Hinges.
Fig. 224.—Gate Without Hinges.
A gate can be made without hinges by having the hanging stile somewhat longer than the front stile, and making both ends rounded. The lower one is to work in a hole in the end of a short post raised so that the soil will not readily get in, and the upper one works in a hole made in an oak piece attached to the top of the gate post. Gates of this kind can be made and hung with but little more expense than bars, and will be found far more convenient and saving of time than the latter.
small gate with iron pinsFig. 225.—Socket Hinges.
Fig. 225.—Socket Hinges.
Fig. 225.—Socket Hinges.
Figure 225represents a small hand-gate hung upon an iron pin driven into a hole bored in the bottom of the hinge-post, and one of similar size and material bent to a sharp angle, and fitted in the top. The lower pin rests in the sill and the upper one extends through the post to which the gate is hung.